Hi.

 Did not get much done today, was out most of the day.

Started installing the saddle tanks tonight. This is not an easy job. I think the pieces are too large for a single build and install. It would have been easier if they were in 2 pieces. Anyway I have the left tank installed  but needs some clean up. And am working on the right tank. The top is glued in place and waiting for it to dry before securing the bottom, Finicky.  :

Here is the right side. There are temp. spacers in-place along the top to hold the tabs down while they dry. Most of the bottom tabs are not yet secure.

[ATTACH=full]43614[/ATTACH]

Hope to get this stage cleaned up tomorrow.

Comments and questions are always welcome.

 Jim