Ello,

Thank you so much friends for such positive works from builders who's work i admire so much

Well enough chit chat........everybody comfortable

Then lets go......

Had a few foam spots to fill,

[ATTACH=full]67589[/ATTACH]

[ATTACH=full]67590[/ATTACH]

Sanded with 80 grit on a sanding block for basic shape, we will get finer later, righ now i'm only interested in basic form

[ATTACH=full]67591[/ATTACH]

Installed two tubes to begin the internals for the rear section, cut to length and screwed in place, with a spacer cut and dry fit on the very back

[ATTACH=full]67592[/ATTACH]

[ATTACH=full]67593[/ATTACH]

Added some more foam fill-ins on the rear

[ATTACH=full]67594[/ATTACH]

Marked,

[ATTACH=full]67595[/ATTACH]

And cut the forward bulk head

[ATTACH=full]67596[/ATTACH]

Marked, cut and boxed off the rear section of the forward bulk head

[ATTACH=full]67597[/ATTACH]

[ATTACH=full]67598[/ATTACH]

[ATTACH=full]67599[/ATTACH]

Main body ready for epoxy resin sealer layer

[ATTACH=full]67600[/ATTACH]

Painted with a layer of resin and left to dry for 24 hours

[ATTACH=full]67601[/ATTACH]

[ATTACH=full]67602[/ATTACH]

Marked and cut 1/8 thick styrene to position as key blend/ transition points

[ATTACH=full]67603[/ATTACH]

[ATTACH=full]67604[/ATTACH]

[ATTACH=full]67605[/ATTACH]

[ATTACH=full]67606[/ATTACH]

Boxed in the forward neck section with 1/8" styrene sheet

[ATTACH=full]67607[/ATTACH]

[ATTACH=full]67608[/ATTACH]

[ATTACH=full]67609[/ATTACH]

[ATTACH=full]67610[/ATTACH]

Started to box in the rear section

[ATTACH=full]67611[/ATTACH]

[ATTACH=full]67612[/ATTACH]

Front,

[ATTACH=full]67613[/ATTACH]

Back

[ATTACH=full]67614[/ATTACH]

[ATTACH=full]67615[/ATTACH]

[ATTACH=full]67616[/ATTACH]

Bondo'ed up ready to sand

[ATTACH=full]67617[/ATTACH]

[ATTACH=full]67618[/ATTACH]

[ATTACH=full]67619[/ATTACH]

[ATTACH=full]67620[/ATTACH]

Gunna let it dry real good and then give her a bit of a sand

But thats next time folks

Until then

Stay frosty

Gag

Out