Thanks for the kind words guys! ;D

Oh G I didn't use the circuit board

as the actual part i only used it's

holes as a template, underneath

it was a square piece of styrene.

I drilled through the board and

then through the styrene, that

made it easy to have them spaced

out correctly.

Ok finally some primer! If your on the

fence about buying the Fine molds kit,

VS. the old one and you can scribe panel

lines and you like the bigger size........LOL

This should make you fall on the side of the

fence for the old kit! LOL

P.S. Nothing is glued down yet still have more

detailing on the small and large boxes.

[ATTACH=full]22784[/ATTACH]

[ATTACH=full]22785[/ATTACH]

[ATTACH=full]22786[/ATTACH]

[ATTACH=full]22787[/ATTACH]

[ATTACH=full]22788[/ATTACH]

[ATTACH=full]22789[/ATTACH]

[ATTACH=full]22790[/ATTACH]

[ATTACH=full]22791[/ATTACH]