Ok still not technically a "cave" but it is a piece of a cave "to be!" and still in progress, but at least it is progressing!

A shot of the paint shelves on the inside right of the cabinet, done except for final finishing. Yeah the cabinet is still on it's side on the work table, so still with the odd camera angles 

The beginning of getting the drawer fronts on. can't seem to find one piece of ply do do the whole thing with a matching pattern, so I am doing it with a few smaller pieces that sort of resemble each other. and purposefully staggering the darker brown area instead of trying to mickey mouse the patter in the wood together. And since this bit of work was to use up the scraps in the garage, I resisted the urge to buy more stock.

More of the drawer fronts, just have to clean up the mark up lines for the hardware, round over the edges, and add the hardware to these ones.

Got a door built up for it, not attached yet. I still want to build a rack in the inside of it beside the porthole windows for my airbrushes, and a shallow rack to hold rulers, straight edges etc. in the bottom half.

With a little imagination, you can almost make out the paint shelves through the window port.

Just a couple more small bits to do, then I will have to roll this mother over on to it's other side and repeat the paint shelves on the other side and the back, finish of the rough work on the inside of the door. Then slide this mother off the table and finish 'er up, then drag it's carcass inside to apply the finish where it has to go. Hopefully I will see this done in the next few weeks. Then I can get on to building out the next bit of this set up.