Reply to thread

Message

Good evening.
I have been working on the first nacelle this weekend.
First thing was to cut out the side panels and shape them, then glue them to the support frame for the nacelle along the fold line.

[ATTACH=full]81976[/ATTACH]

[ATTACH=full]81977[/ATTACH]

When those had dried, then it was the centre skin for the bottom.
Starting aft and working forward. Gluing the sides to the centre skin 1/2" at a time, To get the sides pulled in evenly.

[ATTACH=full]81978[/ATTACH]

[ATTACH=full]81979[/ATTACH]

With the bottom done, it was time to move on to the top.
The centre filler for the nose of the nacelle was first, part 11 pg 23.
Started working from where the piece drops into the chiller area and working forward a bit at a time.

[ATTACH=full]81980[/ATTACH]

This is where I am at right now.

Thank you for following.
Questions and comments welcome.

Jim

<blockquote data-quote="Papermodder" data-source="post: 199062" data-attributes="member: 12832">Good evening.I have been working on the first nacelle this weekend.First thing was to cut out the side panels and shape them, then glue them to the support frame for the nacelle along the fold line.[ATTACH=full]81976[/ATTACH][ATTACH=full]81977[/ATTACH]When those had dried, then it was the centre skin for the bottom.Starting aft and working forward. Gluing the sides to the centre skin 1/2&quot; at a time, To get the sides pulled in evenly.[ATTACH=full]81978[/ATTACH][ATTACH=full]81979[/ATTACH]With the bottom done, it was time to move on to the top.The centre filler for the nose of the nacelle was first, part 11 pg 23.Started working from where the piece drops into the chiller area and working forward a bit at a time.[ATTACH=full]81980[/ATTACH]This is where I am at right now.Thank you for following.Questions and comments welcome. &nbsp;Jim</blockquote>

[QUOTE="Papermodder, post: 199062, member: 12832"] Good evening. I have been working on the first nacelle this weekend. First thing was to cut out the side panels and shape them, then glue them to the support frame for the nacelle along the fold line. [ATTACH=full]81976[/ATTACH] [ATTACH=full]81977[/ATTACH] When those had dried, then it was the centre skin for the bottom. Starting aft and working forward. Gluing the sides to the centre skin 1/2" at a time, To get the sides pulled in evenly. [ATTACH=full]81978[/ATTACH] [ATTACH=full]81979[/ATTACH] With the bottom done, it was time to move on to the top. The centre filler for the nose of the nacelle was first, part 11 pg 23. Started working from where the piece drops into the chiller area and working forward a bit at a time. [ATTACH=full]81980[/ATTACH] This is where I am at right now. Thank you for following. Questions and comments welcome. Jim [/QUOTE]

Verification