Evenin all,

Thanks for your comments my friends, appreciate you stopping by

Lots of faffing about with design elements that always makes me feel i haven't accomplished much.

But here goes,

And were off.

Front wing, after lots of attempts this is what i ended up with, shape wise

[ATTACH=full]63331[/ATTACH]

Marked it out on 1.5mm styrene sheet

[ATTACH=full]63332[/ATTACH]

Cut it out,

[ATTACH=full]63333[/ATTACH]

Cleaned it up,

[ATTACH=full]63334[/ATTACH]

Split it up into its core elements,

[ATTACH=full]63335[/ATTACH]

Using 1.5mm tubing as my transition piece, stuck it back together with some angles

[ATTACH=full]63336[/ATTACH]

Filled with squadron green,

[ATTACH=full]63337[/ATTACH]

Sanded and with some edge profile work done

[ATTACH=full]63338[/ATTACH]

Quick squirt of primer

[ATTACH=full]63339[/ATTACH]

Decided it looked better flipped around so i then added the front elements

First with 'H' cross section piece

[ATTACH=full]63340[/ATTACH]

Then with tube

[ATTACH=full]63341[/ATTACH]

Then a piece of 'U' and a piece of half round on the tip

[ATTACH=full]63342[/ATTACH]

Then it was filled, squadron again

[ATTACH=full]63343[/ATTACH]

Sanded

[ATTACH=full]63344[/ATTACH]

Here you can see the cross section of all the different pieces

[ATTACH=full]63345[/ATTACH]

And then some more precice shaping on all edges

[ATTACH=full]63346[/ATTACH]

[ATTACH=full]63347[/ATTACH]

[ATTACH=full]63348[/ATTACH]

Came up with an idea for the attachment to the nose using tube that i will shape all fancy with sheet and filler later

[ATTACH=full]63349[/ATTACH]

Tube bent and glued

[ATTACH=full]63350[/ATTACH]

Filled,

[ATTACH=full]63351[/ATTACH]

Sanded,

[ATTACH=full]63352[/ATTACH]

Added some 'T' section on the ends, next thinking about more wing elements and the end plate

And thats where i'm at,

[ATTACH=full]63353[/ATTACH]

[ATTACH=full]63354[/ATTACH]

Thats me done, till next time

Take care

Gag

P.S  Come on 3 LIONS.