My first OSL

Palantirion · Nov 5, 2022

This was a cheap resin kit from eBay, roughly 1/12 scale, hollow cast with no back. I used styrene to make the back plate, otherwise not much prep but sanding and re-boring the hole for the support rod. Most of the paint is drybrushing over a black primer, with some stippling and washes also. I have an airbrush, which would have been a better choice for the middle orange tones, but part of the purpose of this project was to work on new drybrushing techniques. I look forward to your feedback.

22,09-12, Slave Leia in carbonite (1).jpg

22,09-12, Slave Leia in carbonite (2).jpg

22,09-12, Slave Leia in carbonite (3).jpg

22,10-25, Slave Leia in carbonite (1).jpg

22,10-25, Slave Leia in carbonite (2).jpg

urumomo · Nov 5, 2022

That's cool , but I think you need to restore some shadow on the shade side of that lower texture . Up to the peaks of those folds .

Palantirion · Nov 5, 2022

urumomo said:
That's cool , but I think you need to restore some shadow on the shade side of that lower texture . Up to the peaks of those folds .

-Thanks, I was actually wondering about exactly that! I may hit it with a colored LED around the upper section and see how the light falls, where shadow cores are, etc. and use that to refine the shadows.

My first OSL

Palantirion

Member

urumomo

Well-Known Member

Palantirion

Member

Similar threads

Latest posts