'64 1/2 Mustang convertible - Monogram

urumomo · Nov 27, 2023

Soak .
toothbrush scrub

C.A. Whitecloud · Nov 28, 2023

Nah, gonna stay with the burgundy. I guess I'll need to paint on the stripes. How hard can it be?

Down Time · Nov 29, 2023

Looking good!!!!

C.A. Whitecloud · Nov 30, 2023

Any tricks to avoid that little paint "wall" you can get at the edge of a stripe when the tape comes off?

Pantherman · Dec 1, 2023

C.A. Whitecloud said:
Any tricks to avoid that little paint "wall" you can get at the edge of a stripe when the tape comes off?

I tend to do several very thinned lawyers which so far has avoided the thick edges on the build when the tape comes off.

C.A. Whitecloud · Dec 1, 2023

Thank you.

A lot of tape for four little stripes.

C.A. Whitecloud · Dec 2, 2023

A couple coats of Flat Black.

Go with the flat, peel tape and continue clear coat entire body?
A coat of Semi-Gloss Black?
A coat of Gloss Black?
Clear coat stripes then peel tape?

I know it comes down to preference, just wish I knew how the different finishes compare. Any insights welcome.

urumomo · Dec 2, 2023

Minimal black , just enough to cover and not build thickness of paint film . Light coat .
Let cure a minimum of 24 hours -- longer is better . Like 3 days .
Remove tape .
Clearcoat entire thing .

C.A. Whitecloud · Dec 2, 2023

Thanks for the reply.

C.A. Whitecloud · Dec 3, 2023

Stripes, check.

Still don't know what to do about the FORD on the hood. Probably should have sanded completely down. I'm not confident to paint the letters by hand. Still hoping to find some PE lettering. Ideas? Full disclosure, I used the decals for the two runner pieces. I did those before I ripped the hood stripes.

C.A. Whitecloud · Dec 5, 2023

Do I need to worry about the tape residue before clear coat?

And yes, I broke the wing window strut. Should I do panel lines now or after some clear? Decals now or after?

C.A. Whitecloud · Dec 6, 2023

Decals, all 4, and panel lines, check.

C.A. Whitecloud · Dec 12, 2023

Test fitting the chassis. How does it sit?

C.A. Whitecloud · Dec 12, 2023

A tad high in front...?

urumomo · Dec 12, 2023

C.A. Whitecloud · Dec 12, 2023

What to do? It's not resting on the frame. Like the chassis is a bit warped.

The rear looks OK.

urumomo · Dec 12, 2023

glue it down

C.A. Whitecloud · Dec 12, 2023

Brilliant!

C.A. Whitecloud · Dec 12, 2023

How about these fiddly bits?

Are there any tricks to get them to lay realistically in the seat? What is the best way to fasten the buckles on? I've never tried these.

C.A. Whitecloud · Dec 13, 2023

More fun bits. Do I need to prime the tiny resin parts?

'64 1/2 Mustang convertible - Monogram

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Similar threads